Insect-O-Cutor® Insect Electrocutors

For use in areas where insect electrocutors are preferred. Our wide range of models provides an excellent choice for use in any area of the facility..... from warehouse... to office area. Insect-O-Cutors® incorporate state-of-the-art design technology (Energy-Efficiency) and special black light lamps that meet our stringent criteria.

Energy Efficient (EE) Models are designed to comply with various energy compliance acts and energy conservation programs. Electronic-ballasted models reduce overall electrical consumption, while increasing light output by 8% to 15% per lamp due to increased operational efficiency. Less energy consumed… more insect attraction light emitted.

High Performance (HP) Models utilize Ultra High Current (UHC) circuitry to increase black light emission for flying insect attraction. An Insect-O-Cutor® innovation, our UHC circuitry overdrives the insect attraction lamps without shortening lamp life.

ALSO SEE: INSECT-O-CUTOR SYSTEM DESIGN

HORIZONTAL HANGING STYLE MODELS WITH INTERNAL COLLECTION DRAWERS

Series 399ET | Series 494ET | Series 599ET

Horizontal Hanging Style Models are designed to protect exterior entries such as truck bays and personnel doors and are ideal for use in high ceiling areas. Flying insect attraction and elimination is achieved via a nearly 360 degree sphere of black light emission and the unit's massive killing grid. These units require minimum ceiling heights of 10.5 feet (3.2 meters) or more.

While it might be desirable to place these models at lower elevations, careful consideration should be given to allow for sufficient clearance of forklift traffic. Insect collection trays on these models are attached exteriorly.

Unit Design Features: Front and rear safety guards; safety switch interrupts electrical current when servicing unit; internal metal insect collection drawer; spring-loaded and fixed lampholder sets for simple lamp installation; three-wire grounded cord and plug. Jacknuts (threaded holes) on unit's side panels accommodate eyebolts. Heavy-duty transformer is shunt-protected.







Series 399ET

(Similar to Series 494ET
below except length of
black light lamps)


Series 399ET units are primarily designed to protect single entry [man] door areas and areas with limited access, these horizontal hanging style models are ideal for use where flying insect populations are low to moderate. (Not available in Canada.)

Series 399ET
  High Performance
Model Numbers		 Energy Efficient
Model Numbers
Metal Finish United States
Aluminized Steel 389T 399ET
Stainless Steel 389TS 399ETS
Black Light Lamps 24 BL Unfiltered and 24B BLB Filtered
Gross Weight of
Specific Models		 Aluminized Steel = 37 Lbs. / 16.8 KG
Stainless Steel = 41 Lbs. / 18.6 KG
Unit Dimensions
With Tray		 29.00" Wide X 27.0" High X24" Deep
(737.0 mm Wide X 686.0 mm High
X 610.0 mm Deep)
Packed Cartons
(Trays are Separate)		 Unit = 3.4 Cubic Feet / 0.10 Cubic Meters
Tray = 2.7 Cubic Feet / 0.08 Cubic Meters



Image of Typical Insect-O-Cutor Hanging Model With Exterior Insect Collection Tray

Series 494ET


Series 494ET units are primarily designed to protect single truck door areas. These mid-size horizontal models should be used where flying insect populations are high enough to be readily observable. (Not available in Canada.)

Series 494ET
  High Performance
Model Numbers		 Energy Efficient
Model Numbers
Metal Finish United States
Aluminized Steel 492T 494ET
Stainless Steel 492TS 494ETS
Black Light Lamps 36 BL Unfiltered and 36B BLB Filtered
Gross Weight of
Specific Models		 Aluminized Steel = 46 Lbs. / 20.9 KG
Stainless Steel = 51 Lbs. / 23.2 KG
Unit Dimensions
With Tray		 42.00" Wide X 27.0" High X24" Deep
(1067.0 mm Wide X 686.0 mm High
X 610.0 mm Deep)
Packed Cartons
(Trays are Separate)		 Unit = 5.3 Cubic Feet / 0.59 Cubic Meters
Tray = 4.0 Cubic Feet / 0.11 Cubic Meters

Series 599ET

(Similar to Series 494ET
above except length of
black light lamps)


Series 599ET units are primarily designed to protect exterior entryways (rail and truck doors); trash and garbage disposal areas; and areas with high levels of competing light, these horizontal style models should be used in areas where maximum flying insect elimination is required. (Not available in Canada.)

Series 599ET
  High Performance
Model Numbers		 Energy Efficient
Model Numbers
Metal Finish United States
Aluminized Steel 589T 599ET
Stainless Steel 589TS 599ETS
Black Light Lamps 48 BL Unfiltered and 48B BLB Filtered
Gross Weight of
Specific Models		 Aluminized Steel = 46 Lbs. / 20.9 KG
Stainless Steel = 51 Lbs. / 23.2 KG
Unit Dimensions
With Tray		 53.00" Wide X 27.0" High X24" Deep
(1347.0 mm Wide X 686.0 mm High
X 610.0 mm Deep)
Packed Cartons
(Trays are Separate)		 Unit = 6.6 Cubic Feet / 0.19 Cubic Meters
Tray = 5.3 Cubic Feet / 0.15 Cubic Meters



Privacy Statement | Directions to our Facility | Contact Us

1641 Lewis Way, Stone Mountain, GA, USA 30083-1107
Phone: (800) 966-8480               (770) 939-2835
Fax: (770) 621-0100




Copyright Insect-O-Cutor November 2006
Best With 1024 X 768 Screens